Sealey SA141 - Manual (Page 2)

 WARNING! Ensure that you read, understand and apply safety instructions before use.
5.1. Only use the impact sockets which are supplied with this tool or those specifically designed for use with an impact wrench. DO NOT
use worn or damaged sockets.
5.2. Connect the wrench to the air supply as described in Section 4.
5.3. Place the socket over the top of the glow plug and depress the trigger to operate the wrench.
5.4. To change rotation, push the slide button at the top of the handle. Move it in the direction F for forward (clockwise) and in the direction
R for reverse (anticlockwise) see fig.3.
5.5. The torque may be regulated by adjusting the air regulator valve at the base of the handle.
5.6. DO NOT allow the wrench to free run for an extended period as this may damage the bearings.
 WARNING! Disconnect the wrench from the air supply before changing accessories, servicing or performing maintenance. Replace or
repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
6.1. If the air supply system does not have an oiler, lubricate the wrench daily with a few drops of Sealey air tool oil dripped into the air inlet.
6.2. Clean the wrench after use.
6.3. Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type of hose connectors. To rectify, check the
air supply and follow instructions in Section 4.
b) Grit or gum deposits in the wrench will also reduce performance. If your model has an air strainer (located in the air inlet), remove
the strainer and clean it. Flush the wrench out with gum solvent oil or an equal mixture of SAE 10 oil and paraffin. Allow to dry before
use.
6.4. When not in use, disconnect from the air supply, clean and store in a safe, dry, childproof location.
4.2. Couplings
Vibration may cause failure if a quick-connect coupling is fitted directly to the wrench. To overcome this, connect a leader hose to the
wrench. A quick-connect coupling may then be used between the leader hose and the air line recoil hose. See figs. 1 & 2.
5. OPERATION
6. MAINTENANCE
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
fig.2
fig.3
fig.1
SA141 Issue: 1 - 10/11/14
Original Language Version © Jack Sealey Limited