Sealey SA6001 - Manual (Page 3)


WarninG! Disconnect wrench from air supply before changing accessories, servicing or
performing maintenance. replace or repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
5.1. if the air system does not have an oiler lubricate the air wrench daily with a few drops of
Sealey air tool oil dripped into the air inlet
5.2. Check and top up the gearbox by removing grub screw located under the impact head.
5.3. Clean the wrench after use. Do not use worn, or damaged sockets.
5.4. loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. incorrect size or type
of hose connectors. to remedy check the air supply and follow instructions in chapter 3.
b) Grit or gum deposits in the wrench may also reduce performance. if your model has an air
strainer (located in the area of the air inlet), remove the strainer and clean it. Flush
the wrench out with gum solvent oil or an equal mixture of SAE No 10 oil and paraffin. Allow
to dry before use.
5.5. For a full service contact your local Sealey service agent.
5.6. When not in use, disconnect from air supply, clean wrench and store in a safe, dry,
childproof location.
5. Maintenance
Original Language Version
SA6001.V2 issue: 4 (SP) - 22/08/13 © Jack Sealey limited 2013