Sealey SA29/S - Manual (Page 3)


WARNING! Disconnect wrench from air supply before changing accessories, servicing or
performing maintenance . Replace or repair damaged parts . Use genuine parts only.
Non-authorised parts may be dangerous and will invalidate the warranty.
5 .1 . If the air system does not have an oiler lubricate the air wrench daily with a few drops of
Sealey air tool oil dripped into the air inlet to prolong its life .
5 .2 . Clean the wrench after use . DO NOT use worn, or damaged sockets .
5 .3 . Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line . Moisture or restriction in the air pipe . Incorrect size or
type of hose connectors . To remedy check the air supply and follow instructions in
chapter 3 .
b) Grit or gum deposits in the wrench may also reduce performance . If your model has an
air strainer (located in the area of the air inlet), remove the strainer and clean it . Flush
the wrench out with gum solvent oil or an equal mixture of SAE No 10 oil and paraffin .
Allow to dry before use .
5 .4 . For a full service contact your local Sealey service agent .
5 .5 . When not in use, disconnect from air supply, clean wrench and store in a safe, dry,
childproof location .
5. MAINTENANCE
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product .
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim .
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode .
01284 757500
01284 703534 sales@sealey .co .uk
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St . Edmunds, Suffolk,
IP32 7AR
www .sealey .co .uk
W e b
email
Original Language Version
SA29/S .V3 Issue: 4- 11/07/13 © Jack Sealey Limited
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste .
All tools, accessories and packaging should be sorted, taken to a recycle
centre and disposed of in a manner which is compatible with the environment .