Sealey SA153 - Manual (Page 3)


WARNING! Disconnect the grinder from air supply before changing the disc, servicing or performing
maintenance.Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
5.1. Lubricate the grinder daily with a few drops of good grade air tool oil, such as Sealey ATO/500 or
ATO/1000, dripped into the air inlet before use or dispensed automatically through an air system oiler,
such as Sealey model SA100L or SA2001/L.
5.2. Clean the grinder after use and change the disc when worn or damaged.
5.3. Loss of power or erratic action may be due to the following:
a) Excessive drain on the air supply. Moisture or restriction in the air line. Incorrect size or type of hose
connectors. To remedy check the air supply and follow instructions in Section 3.
b) Grit or gum deposits in the grinder may also reduce performance. Flush the grinder with gum solvent
oil or an equal mixture of SAE No 10 oil and kerosene. Allow to dry before use.
If you continue to experience problems, contact your local Sealey service agent.
5.4. When not in use, disconnect from air supply, clean grinder and store in a safe, dry, childproof location.
4. OPERATING INSTRUCTIONS
5. MAINTENANCE

WARNING! Ensure that you read, understand and apply the
safety instructions before use.
4.1. Assembly
4.1.1. To attach the grinding disc you will need the two spanners provided, one to
hold the spindle and the other to loosen/tighten the flange nut.
4.1.2. To put on a grinding disc hold the spindle with one spanner and with the
protruding side of the disc facing down toward the spindle, screw on the
flange nut and tighen with the second spanner.
4.1.3. Connect air supply to grinder and push up the safety catch, then squeeze the control valve lever to
check that the grinder is working correctly.
4.2. Operating
DO NOT apply excessive pressure, let the grinder do the work for you. Start the grinder and bring the disc
to the the work surface evenly and slowly. Move the grinder back and forth in overlapping areas.
Remove the grinding disc from the work surface before stopping the grinder. Regularly check the
condition of the disc and always change if worn, cracked or otherwise damaged.
DO NOT run the grinder off the workpiece for extended periods as this will shorten the life of the bearings.
 WARNING! Use only discs with speed ratings equal to, or higher than, the speed rating of the
grinder.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
Original Language Version
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment.
SA153 Issue: 3(SP) - 23/07/13 © Jack Sealey Limited