Sealey SA14 - Manual (Page 3)

 WARNING! Disconnect the grinder from air supply before changing the disc, servicing or performing
maintenance.Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
5.1. Lubricate the grinder daily with a few drops of good grade air tool oil, such as Sealey ATO/500 or
ATO1000, dripped into the air inlet before use or dispensed automatically through an air system oiler,
such as Sealey model SA100L.
5.2. Clean the grinder after use and change the disc when worn or damaged.
5.3. Loss of power or erratic action may be due to the following:
a) Excessive drain on the air supply. Moisture or restriction in the air line. Incorrect size or type of
hose connectors. To remedy check the air supply and follow instructions in Section 3.
b) Grit or gum deposits in the grinder may also reduce performance. Flush the grinder with gum
solvent oil or an equal mixture of SAE No 10 oil and kerosene. Allow to dry before use.
If you continue to experience problems, contact your local Sealey service agent.
5.4. When not in use, disconnect from air supply, clean grinder and store in a safe, dry, childproof
location.
4. OPERATING INSTRUCTIONS
5. MAINTENANCE
 WARNING! Ensure that you read, understand and apply the safety
instructions in Section 1 before use.
4.1. Assembly
4.1.1. The SA14 comes with a steel guard and hub wrench.
4.1.2. The steel guard fits over the front of the cylinder housing with the clamp
at the top of the tool. Secure in place using a hex key.
4.1.3. Remove the disc locking flange nut from the grinder spindle.
Use the hub wrench supplied to prevent the spindle from rotating.
4.1.4. Fit the grinding disc (not supplied) to the spindle and retain with the flange nut. Use only discs with
speed ratings equal to, or higher than, the speed rating of the grinder.
4.1.5. Connect air supply to grinder and squeeze the trigger to check that the grinder is working correctly.
4.2. Operating
DO NOT apply excessive pressure, let the grinder do the work for you. Start the grinder and bring the
disc to the the work surface evenly and slowly. Move the grinder back and forth in overlapping areas.
Remove the grinding disc from the work surface before stopping the grinder. Regularly check the
condition of the disc and always change if worn, cracked or otherwise damaged.
DO NOT run the grinder off the work-piece for extended periods as this will shorten the life of the
bearings.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
Original Language Version SA14.V3 Issue:3(SP)-18/06/13 © Jack Sealey Limited