Sealey SA614 - Manual (Page 3)

5. MAINTENANCE
DO NOT allow hammer to free run for an extended period of time, as this will shorten its life.

WARNING! Disconnect hammer from air supply before changing accessories, servicing or
performing maintenance. Replace or repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
5.1. If the air system does not have an oiler, lubricate the air hammer daily with a few drops of
Sealey air tool oil dripped into the air inlet.
5.2. Clean the hammer after use. DO NOT use worn or damaged chisels.
5.3. Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restrictionin the air pipe. Incorrect size or
type of hose connectors. To remedy, check the air supply and follow instructions in
Section 3.
b) Grit or gum deposits in the hammer may also reduce performance. Flush the hammer
out with gum solvent or an equal mixture of SAE10 oil and paraffin. Allow to dry before
use.
5.4. For a full service, contact your Sealey agent.
5.5. When not in use, disconnect from the air supply, clean the air hammer and store it in a
safe, dry, childproof location.
4. OPERATING INSTRUCTIONS
4.1. Insert the chisel shank into the gun cylinder (fig.3).
4.2. Place the retainer ring over the chisel (fig.3) and lower onto the hammer’s cylinder thread.
Wind the retainer spring on to the cylinder using a clockwise motion until the spring is fully
located and the chisel is retained by the spring’s retaining tag (fig.4).
4.3. To remove attachment, reverse procedures in 4.1 to 4.2.
4.4. Connect the tool to the air supply as described in Section 3.
4.5. To operate the hammer, squeeze the trigger, taking care that the chisel end is not in
contact with the workpiece.
fig.3
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
fig.4
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Original Language Version
SA613.V2, SA614.V2 Issue: 1 - 04/10/13 © Jack Sealey Limited
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycle centre and disposed
of in a manner which is compatible with the environment.
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on
to www.sealey.co.uk, email [email protected] or phone 01284 757500.