Emerson E2 User Manual
Page 224
C-2
•
E2 RX/BX/CX I&O Manual
Application Setpoint Has Changed 99
A user has changed a setpoint in one of E2’s applica-
tions.
Application Was Created
99
A user has created a new application in this E2.
Application Was Deleted
99
A user has deleted an existing application in this E2.
ARTC/MultiFlex RTU Override
Switch Stuck
20
An override switch on an ARTC/ MultiFlex RTU has
been ON for a prolonged period of time, suggesting a
possible switch failure.
ARTC/MultiFlex RTU Reset From
Power Failure
50
An ARTC/MultiFlex RTU lost power and reset when
power was restored.
Attempt To Write Past Mem. EOB 50
The E2 attempted to write data to memory, but the
memory was full.
Average Log Stuck-No Memory
15
The Average Log cannot be written because there is
not enough memory.
Bad Modem
20
The modem on this E2 is not functioning properly.
Battery backed memory lost
30
Battery backed memory loss not due to cleanout.
Batt Runtime Limit
99
Battery runtime has exceeded 80% of the battery life-
time.
Binding Input To Output Failed
20
A valid connection could not be made between an
input and an output.
BIOS/BIOS Ext. Update Failed
20
An update to the E2’s BIOS has failed.
BIOS/BIOS Extension Updated
50
The E2’s BIOS was successfully updated.
Can't Set Hardware Clock
20
The E2 is unable to change the time on its hardware
clock.
Case Cleaning Was Started
User
A case circuit has entered clean mode.
Case Temp Hi Limit Exceeded
User
A single temperature sensor in a Standard Circuit or
Case Control Circuit is recording a temperature
higher than its defined case temperature high set-
point.
Case Temp Low Limit Exceeded
User
A single temperature sensor in a Standard Circuit or
Case Control Circuit is recording a temperature lower
than its defined case temperature low setpoint.
Cell Config Not Restored
15
E2’s attempt to restore configuration data to its appli-
cations has failed.
Cell Create Failed For Restore
20
E2 attempted to create new applications as part of the
configuration restoration process and failed to do so
successfully.
Checkit Sensor Has Failed
User
A Checkit sensor is returning an invalid temperature
value, indicating a sensor failure.
Checkit Sensor Is Alarming
User
A Checkit sensor on a Suction Group application is
recording a high temperature.
Checkit Sensor Is In Notice
User
A Checkit sensor’s temperature is above its pro-
grammed notice setpoint.
Alarm Name
Default
Priority
Definition