Epson WorkForce 600 Series - Manual (Page 40)

40 Maintaining Your All-in-One
Replacing Ink Cartridges
Make sure you have a new ink cartridge before you begin. You must install new
cartridges immediately after removing the old ones.
Caution:
Do not open ink cartridge packages until you are ready to install the ink. Cartridges are
vacuum packed to maintain reliability.
Leave the expended cartridge(s) installed until you have obtained a replacement, or the
ink remaining in the print head nozzles may dry out.
1. Turn on the WorkForce 600 Series.
If a cartridge is low or expended, you see a message
on the display screen. Note which cartridges need to
be replaced and press
OK . (You cannot print until
you have replaced any expended ink cartridges.)
If you’re replacing a cartridge before you see a
message on the display screen, press the
Home
button, press l or r to select Setup , and press OK .
Press l or r to select Maintenance and press OK .
Select Ink Cartridge Replacement and press OK .
2. Open the scanner, then open the cartridge cover.