Ceramic baffle installation, Fan wiring diagram, Installation – Enviro Kodiak 1200 Insert User Manual

Page 42

ERAMIC

AFFLE

NSTALLATION

1. Remove the front secondary air tube by placing a screwdriver (any style except flat head) into one of

Left Ceramic

Baffle

Right Ceramic

Baffle

Figure 50: Installation of Ceramic

Baffle.

��

�� 

Installation

Figure 51: Fan Kit Wiring Diagram.

IRING

IAGRAM

This appliance, when installed, must be electrically connected and grounded in accordance with local

codes or in the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE. Part

1, SAFETY STANDARDS FOR ELECTRICAL INSTALLATIONS, or THE NATIONAL ELECTRICAL CODE ANSI

/ NFPA 70 in the USA.

CAUTION Label all wires prior to disconnection when servicing controls. Wiring errors

can cause improper and dangerous operation. Verify proper operation after servicing.

DO NOT cut or remove the grounding prong from the plug.

DO NOT route the power cord beneath the heater.

WARNING: This appliance is equipped with a three-prong (grounding) plug for your protection against

shock hazard and should be plugged into a properly grounded three-prong receptacle.

This is a basic wiring diagram for the option

fan installation.
1) Plug the fan assembly into a three (3)

prong (grounded) receptacle.

2) Turn the fan controller to the desired

setting.

3) Once the unit has reached operating

temperature, the fan temperature sensor

will turn the fan on automatically.

4) When the unit cools down the fan

temperature sensor will shut the fan off

automatically.

DO oil the fan bearings regularly.

the air holes and tapping it with a hammer/mallet to the left. Step

1 is only required on the insert models.

2. Slide the right ceramic baffle in over the secondary air tubes at the

top of the firebox. The tab must be on the top and pointing towards

the center and the smooth side is to face down.

3. Hook the outside edge of the baffle over the top of the secondary

air chamber. This will make room to for the installation of the left

ceramic baffle.

4. Slide the left ceramic baffle in over the secondary air tubes. The tab

must be on the bottom and pointing towards the center and the

smooth side is to face down.

5. Pull the baffles together in the middle so the right tab rests on top

of the left tab. Ensure the baffles are flush with the back and both

sides of the firebox.