Legs and ash pan installation - freestanding, Installation – Enviro Kodiak 1200 Insert User Manual

Page 23

• Place the unit on the pallet on its

back.

• Attach pedestal spacer to bottom

of the unit, using the supplied

screws.

• Attach the air channel box to the

front of the pedestal spacer using

two (2) T-20 screws.

• Slide the ash pan assembly over

the bolts, using the key-holed

slots provided, and tighten all four

(4) bolts.

• Carefully remove the cast iron

legs from the packaging and

secure each leg with two (2) bolts

provided.

• Secure all four (4) legs, push the

Figure 17: Installing Legs and Ash Pan Assembly.

Installation

EGS

NSTALLATION

- F

REESTANDING

��

The heat-efficiency shield is installed to lower the

clearances to combustibles on the flat top freestanding

model.

1. The unit must be in position for the installation and

with the venting ready to be assembled.

2. Loosen the two (2) top screws on the back of the

unit using a

” socket.

3. Place the heat-efficiency shield on top of unit.
4. Slide chimney connector through the heat-

efficiency shield and over the flue.

5. Lift the heat-efficiency shield and screw the

chimney connector to the flue.

6. Slide the heat-efficiency shield down and hook the

slot at the back of the shield, around the loosened

screws at the back of the unit.

7. Tighten the two (2) screws at the back.

Figure 18: Installing Heat Shield.

leg towards the center of the stove and align the legs with the outer edges of the firebox.

• Stand the unit on the legs and set the unit in the location ready for installation.

NSTALLATION

EAT

-E

FFICIENCY

HIELD

- F

REESTANDING

LAT