2 client bridge mode, 3 wds bridge mode – EnGenius Technologies EOC5611P User Manual

Page 62

to connect with or enter SSID manually.

Step3

Configure VLAN ID in your wireless device if available.

Step4

Select correct authentication type and password.

Auction: EOC5611P’s Access Point Mode does not provide DHCP server so the Wireless Client IP address must configure

manually at the same subnet in Local Area Network.

9.2 Client Bridge Mode

Client Bridge Mode functions like a wireless dongle. It must connect to an Access Point/AP Router to

join the network.

Please refer to the last section to check Access point’s configuration.

Client Bridge

Step1

Step2

Select your country or region’s regulation.

Step3

Select Operation Mode to Client Bridge from System Properties.

Step4

802.11a/b/g wireless network.

Step5

Use site survey to scan Access Points that are available in nearby area.

Step6

Select the AP you would like to associate with.

Step7

Setup the authentication settings that match to the Access Point’s setting.

Step8

Press Apply to process all the configurations.

Auction: Client Bridge’s IP setting must match to the Access Point’s subnet.

9.3 WDS Bridge Mode

Use this feature to link multiple APs in a network. All clients associated with any APs can

communicate each other like an ad-hoc mode.