EnGenius Technologies EOC5611P User Manual

Page 28

Data Rate

Select Data Rate from the drop down list. Data rate will affect the efficiency of the

throughput. If the data rate is set to a small number, the lower through will get but it

can transmit to longer distance.

Transmit Power

Select Transmit Power to increase or decrease Transmit Power. Higher transmit

power will sometimes cause unable to connect to the network. On the other hand,

the lower transmit power will cause client unable to connect to the device.

Antenna

Select antenna waveform from Diversity, Vertical or Horizontal.

Fragment Length

Specify package size during transmission. If large amount of client are accessing to

the network, specify small number of the fragment length in order to avoid collision.

RTS/CTS Threshold

Specify Threshold package size for RTC/CTS. Using small number of the threshold will

cause RTS/CTS packets to be sent more often to consuming more of the available

bandwidth. In addition, if the heavy load traffic occurs, the wireless network can be

recovered easily from interferences or collisions.

Protection Mode

Select Disable or Enable Protection Mode. If there are large amount of error occur

during the transmission, please enable the protect mode otherwise protect mode

should remain disable.

WMM

Select Disable or Enable WMM function. WMM is based on the four Access

Categories: voice, video, best effort and background. WMM function is not used to

guarantee transmission speed.

Channel Bandwidth

Select Channel Bandwidth from the drop down list. Decrease channel bandwidth

may cause lower throughput but less collision.

Distance

Specify distance rage between AP and Clients. Longer distance may lose high

connection speed.

Wireless Traffic Shaping

Place a Check to enable Wireless Traffic Shaping function.

Incoming Traffic Limit

Specify the wireless transmission speed for downloading.

Outgoing Traffic Limit

Specify the wireless transmission speed for uploading.

Auction: Changing Wireless Advanced Settings may cause insufficient wireless connection quality.

Please remain all settings as default unless you have acknowledged all changing that you have made.

Note: The Internal Antenna is only work for 5GHz wireless network. If you would like to use 2.4GHz

wireless network, you must connected an External Antenna and switch the antenna types from the

bottom of the device (Close to the Ethernet Port).