Eclipse - Fujitsu Ten ECLIPSE CD3200 - Manual (Page 93)

How to operate the tuner with an optional SIRIUS satellite radio tuner connected (U.S.A./CANADA only)
93
XVIII
Category selection
The channel can be selected from among
categories such as POP and ROCK.
Consult the SIRIUS website for the details of
the categories.
The category will switch in the order
shown below each time button is
pressed.
Up:
Advances to the next category.
Down:
Returns to the previous category.
Direct channel selection
The channel can be selected by inputting the
channel directly.
The mode will change to the direct
channel selection mode.
Right:
Advances to the next number.
Left:
Returns to the previous number.
Each time the button is pressed, the
channel number changes in the
following order.
0 ↔ 1 ↔ 2 ↔ 3 ↔ 4 ↔ 5 ↔ 6 ↔ 7 ↔
8 ↔ 9 ↔ 0 ↔ www
Reception starts.
Manually storing channels into
memory
This section covers the storing of stations in the
memory of numbered buttons.
The tuned channel is now memorized
and stored in the button selected.
Repeat the procedure to stored
additional manually tuned channels
into memory, in turn, for buttons [1] to
[6]. These buttons are called the
preset buttons.
ATTENTION
If the vehicle’s battery is disconnected (for
repairs to the vehicle or when removing the
main unit), all channels stored in memory will
be lost. In such cases, store the channels in
memory again.
Preset channel scan
This function enables the reception of all the
channels in the preset buttons for five seconds
each.
[P SCAN] will appear on the display,
and channels stored in preset buttons
[1] through [6] will be received for five
seconds each.
1
Press the [SELECT] (Up/Down)
button for less than one second.
1
Press the [MODE] button for more
than one second.
2
Press the [SELECT] (Right/Left)
button to select the channel
number.
3
Press the [SELECT] (Up/Down)
button to select the channel
number to be input.
4 Press the [ENTER] button.
1
Press the [SELECT] (Right/Left)
button to tune to the channel to be
stored in the memory.
2
Select any button, from [1] to [6],
and press it for more than two
seconds.
1
Press the [SELECT] (Down) button
for more than one second.