Eclipse - Fujitsu Ten ECLIPSE CD3200 - Manual (Page 70)

70
Various Settings
Each time the button is pressed, the Q
curve pattern changes in the following
order.
When BASS is selected:
WIDE ↔ MidWIDE ↔ NORMAL ↔
NARROW ↔ WIDE ↔ www
When MIDDLE is selected:
NORMAL ↔ NARROW ↔ NORMAL ↔
www
When TREBLE is selected:
NORMAL (Fixed)
Each time the button is pressed, the
frequency changes in the following
order.
When BASS is selected:
60Hz ↔ 80Hz ↔ 100Hz ↔ 120Hz ↔
60Hz ↔ www
When MIDDLE is selected:
700Hz (fixed)
When TREBLE is selected:
7.5kHz ↔ 10kHz ↔ 12.5kHz ↔ 15kHz
↔ 7.5kHz ↔ www
ATTENTION
• The median frequency and the Q curve you
set are used for BASS, MIDDLE and
TREBLE in the audio control mode. (For
details, Refer to "How to operate the AUDIO
CONTROL" on page 64.)
• When the median frequency and the Q
curve are adjusted, CUSTOM EQ is also
updated.
Position selector
The sound field can be adjusted for the listener's
seat position.
The position selector setting mode is
activated.
When each button is pressed, the
position is changed as follows.
ENTER:
OFF
Up:
FRONT
Down:
REAR
Right:
FRONT-RIGHT
Left:
FRONT-LEFT
Crossover adjustment (X-Over)
Specified frequency bands are allocated to each
speaker for improved sound integration.
The crossover setting mode is
activated.
2
Press the [SELECT] (Up/Down)
button to adjust the Q curve
pattern.
3
Press the [SELECT] (Right/Left)
button to adjust the frequency.
1
Press the [SELECT] (Up/Down)
button to select Position Sel.
2 Press the [ENTER] button.
3
Press the [ENTER] or [SELECT]
(Up/Down/Right/Left) button to
select the position you want.
1
Press the [SELECT] (Up/Down)
button to select the X-Over.
2 Press the [ENTER] button.