beautypg.com

When you think there is a malfunction – Eclipse - Fujitsu Ten ECLIPSE CD3200 User Manual

Page 104

background image

104

Other information

When you think there is a malfunction

A slight difference in operation may be mistaken for a malfunction. Please check the items in the
following table first.
If the unit does not work, even after the appropriate remedial action has been taken, please contact
your dealer.

Mode

Problems

Causes

Remedial action

Refer

to

page

All

The sound is

difficult to hear

or cannot be

heard at all.

Is the volume sufficient?

Turn up the volume.

18

Is the muting function activated (MUTE)?

Cancel the muting (MUTE)
function.

18

Is the fader or balance control set to one
side?

Readjust the fader and

balance controls to normal

positions.

64

Other probable causes include broken or

pinched audio-signal wires, a faulty

speaker, or a detached connector.

Have your dealer check the
problem.

Power does not

come on.

Are there too many electrical items
installed, causing a lack of available power?

Have your dealer check the
problem.

Other probable causes include a run-down

car battery, a blown fuse, or pinched or

broken power or communication wires.

Have your dealer check the
problem.

Frequencies or

titles set in

memory have

been deleted.

Has the car battery been disconnected for
repairs or inspections?

Reenter the frequencies or
titles into memory.

43

Are there too many electrical items
installed, causing a lack of available power?

Have your dealer check the
problem.

Other probable causes include a run-down

car battery, a blown fuse, or pinched or

broken power or communication wires.

Have your dealer check the
problem.

There is no

guide tone.

Is the guide tone set to OFF?

Reset the guide tone to ON.

77

The remote

control does not

work.

Are the batteries low?

Replace the batteries.

47

Are the batteries installed correctly?
(reversed polarity)

Reinstall the batteries
correctly. (correct polarity)

47

Is direct sunlight hitting the remote control
light receptor?

Use the remote control in

closer proximity to the

receptor.

There may be a malfunction in the remote
control unit.

Have your dealer check the
problem.