Epson S70670 - Manual (Page 58)

Basic Operations 58
20. Close the front cover.
Loading Media - S30670
The procedure for loading media varies depending on whether you are using the installed
media feeding unit or the optional heavy roll media system.
Follow the steps below when using the supplied media feeding unit.
When the Heavy Roll Media Feeding Unit is installed, see “Using the Optional Heavy Roll
Media Feeding Unit” on page 68.
When the Standard Media Feeding Unit Is Installed
This section describes how to load media when the standard media feeding unit is
installed.
1. Turn on the printer by pressing the P button.
2. Loosen the roll holder fixing screws and adjust the roll holders so that the gap between
the two is wider than the media.
Important:
❏ Do not use the media holding plates with media that is more than 0.4 mm (0.02 inch)
thick. The media holding plates could touch and damage the print head.
❏ Move the media holding plates to the left and right edges of the platen when they are
not in use.
❏ Do not use the media holding plates if the sides of the printed media are smudged or
torn.
❏ Leave left and right margins of over 10 mm (0.39 inch) when using the media holding
plates. Narrower margins could result in printer printing over the plates (this does not
apply when ink layering is used).
c
Caution:
❏ Because the media is heavy, it should not be carried by one person. When loading or
removing the media, use at least two persons.