Epson S70670 - Manual (Page 148)

Using the Control Panel Menu 148
Menu Item Parameter
Media Setup
See “The Media Setup
Menu” on page 152.
Media Remaining
Remaining Setup On, Off
Length 5.0 to 99.5 m (15 to 300 ft)
Remaining Alert 1 to 15 m (4 to 50 ft)
Print Remaining Length Print
Select Media RIP Settings, 1 to 30 (media setting bank number)
Customize Settings
Current Settings Change settings for currently selected media. The options
available depend on whether RIP Settings or a media setting
bank is selected. The options available for RIP settings and
media setting banks 1 to 30 are listed below.
RIP Settings
Platen Gap 1.5, 2.0, 2.5
Head Alignment
Input thickness. Auto(Uni-D), Auto(Bi-D), Auto(Dual Head)
1
, Manual(Uni-D),
Manual(Bi-D), Manual (Dual Head)
1
Roll Type Printable Side Out, Printable Side In
Tension Measurement Periodically, Every Page, Off
Media Tension 0 to 40
1 to 30 (media setting bank)
Setting Name Up to 22 half-size characters
Feed Adjustment Auto, Manual
Platen Gap 1.5, 2.0, 2.5
Head Alignment Auto(Uni-D), Auto(Bi-D), Auto(Dual Head) 1 , Manual(Uni-D),
Manual(Bi-D), Manual (Dual Head)
1
Heating & Drying
Heater Temperature Pre-heater/platen heater: 30 °C to 50 °C (86 °F to 122 °F)
After heater: 30 °C to 55 °C (86 °F to 131 °F)
Drying Time Per Pass 0 to 10 sec
After Heater Feed Mode 1, Mode 2, Off
Additional Dryer On, Off