Epson S70670 - Manual (Page 55)

Basic Operations 55
14. Hold the center of the media and raise the media loading lever.
15. Pull the media straight forward until the edge has past the label on the left side of the
after heater.
Keep the right edge of the media parallel with the scale markings on the two labels on
the right side of the after heater.
16. Adjust the position of the pressure rollers.
The low pressure rollers are used for normal printing, the high pressure rollers for ink
layering. Their positions vary with the width of the media and the rollers used.
Important:
Perform Steps 14 to 3 in reverse order and repeat the loading process if the right edge of
the media is not within the scale markings. Do not attempt to reposition the roll holders
while they are inserted in the media.