Epson S70670 - Manual (Page 13)

Introduction 13
Front section - S30670
1 Maintenance cover (left)
Open this cover to clean the area around the print head. Normally closed when using the printer.
See “Cleaning Around the Print Head” on page 126.
2 After heater
The heater can be used to rapidly dry ink after printing.
See “Heating & Drying” on page 97.
3 Roll core holder
Place the used roll core for media take-up on these holders. There are two holders: one on the left and one on the right.
See“Media Loading and Take Up” on page 82.
4 Tensioner
The tensioner maintains tension to prevent the media sagging as it is taken up.
5 Roll core holder locking screw
The locking screws keep the roll core holders in place once they have been attached to the roll core. There are two locking
screws: one on the left and one on the right.
6 Roll support
Rest media temporarily on these supports when removing the take-up roll. There are two supports: one on the left and one on
the right.
7 Auto switch
Use this switch to select the auto take-up direction. Choose Off to disable auto take-up.