Epson Stylus TX100 - Manual (Page 110)

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 Revision A
MAINTENANCE Overview 110
Confidential
6.1.3 Lubrication
The type and amount of the grease used to lubricate the printer parts are determined
based on the results of the internal evaluations. Therefore, be sure to apply the
specified type and amount of the grease to the specified part of the printer mechanism
on the following occasion.
† Any parts required the lubrication are replaced.
† The printer is disassembled/assembled. (If necessary)
† Refer to the following figures for the lubrication points.
Figure 6-1. Lubrication on Driven Pulley Holder
Figure 6-2. Lubrication on Lower Housing (1)
C A U T I O N
„ Never use oil or grease other than those specified in this
manual. Use of different types of oil or grease may damage the
component or give bad influence on the printer function.
„ Never apply larger amount of grease than specified in this
manual.
Table 6-1. Specified Lubricant
Type Name EPSON Code Supplier
Grease G-8AF TBD EPSON
Contact points (x 2) with the
Pulley.
G-8AF
Size of a grain of rice
Use an injector to apply G-71.
Contact points (x 2) with the EJ
Roller.
G-8AF
Adequate dose
† Before installing the EJ Roller.
† Use an injector.
Driven Pulley Holder
Lower Housing