Epson Stylus TX100 - Manual (Page 98)

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Scanner Unit 98
Confidential
6. Disengage the shafts on both ends of the CIS Unit from the bearing holes of
the Scanner CR Holder, and remove the unit.
Figure 4-111. Removing the CIS Unit
CIS Unit
Shaft and Shaft hole
Scanner CR Holder
„ Install the CIS springs (x2) to the dowels of the Scanner CR
Holder. (See Fig.4-112. )
Figure 4-112. Installing the CiS Spring
„ When installing the spacers, be sure to place them with the
cutout facing inward. (See Fig.4-113. )
Figure 4-113. Replacing the Spacers
Scanner CR Holder
CIS Spring
Dowel
Spacer