Nikon KeyMission 170 - Manual (Page 31)

12
Getting Started
Camera Setup
3
Pair (i.e., establish a Bluetooth link between) the camera and the
smart device.
• Android Devices with NFC Support
After checking that NFC is enabled on the smart
device, touch the camera
Y (N-Mark) to the NFC
antenna on the smart device to launch the
SnapBridge 360/170 app.
- If the SnapBridge 360/170 download site is
displayed, download and install the app before
repeating the above steps.
• iOS Devices and Android Devices Without
NFC Support
On the camera, press
H or I to select Next, and
press k. The camera will wait for a connection;
launch the SnapBridge 360/170 app on the smart
device and follow the on-screen instructions to tap
the name of the camera you want to pair with.
4
Check the authentication code.
• When the message is displayed prompting you to
confirm the authentication code, scroll down the
screen to view the authentication code.
• After confirming that the camera and smart device
display the same six-digit authentication code,
follow the steps below to complete pairing (note
that the code may not be displayed in some
versions of iOS, but you should follow the steps
below even if the code is not displayed).
- On the camera, press
H or I to select OK, and press k.
- On the smart device, tap Pairing (the name of the button varies with the smart
device).
App
SnapBridge 360/170
Camera
Camera name_XXXX
Cancel
Connect to Camera
Camera name
device and select OK.
Auth. code
000000
OK
Back
Camera