Casio EA-200 - Manual (Page 7)

20020601
English
Chapter 1
General Guide
P button (rear side)* 2
Key Functions and Indicator Lamps
࡯ Key Functions
To do this: Press this key:
Start a sampling operation from the ready state [START/STOP]
Stop an ongoing sampling operation [START/STOP]
Use Auto Setup (See “Auto Setup” on page 1-5.) [SET UP]
Cancel the ready state [SET UP]
࡯ Indicator Lamps
When this indicator lamp: Does this: It means this:
Power (Green) Lights Power is on.
Ready (Green) Lights EA-200 is standing by for data (ready state).
Sampling (Green) Flashes Sampling is in progress.
Error (Red) Lights An error occurred.
Batt (Red) Lights It is time to replace the batteries.
1-1
Ready Sampling Error Batt Power
SET UP START/STOP
• While the “Ready” lamp is lit, press the [START/STOP] key to start sampling.
• To cancel the ready state, press the [SET UP] key.
• To interrupt a sampling operation, press the [START/STOP] key.
• For details about errors, see “Status Request” on page 1-5.
* 1 When using the EA-200 in combination
with the optional “Motion Sensor (EA-2)”,
be sure to power the EA-200 using its
bundled AC adaptor (AD-A60024).
* 2 If you start to experience serious operational problems with the EA-200, use a thin, pointed
object to carefully press the P button on the back of the EA-200. Note, however, that pressing
the P button deletes all data currently in EA-200 memory. Proper operation does not resume
after you press the P button, remove its batteries, and then replace them correctly in
accordance with the instructions on page 0-3 of the User’s Guide.
Digital input/output port
Serial 232C (9-pin) port
(for cross cable)
External microphone 2-pin port
(for condenser microphone)
Volume
External speaker 2-pin port
AC adaptor port
SONIC Channel
EA-2* 1
Calculator 3-pin
communication port
(SUB port)
× 7
Calculator 3-pin
communication port
(MASTER port)
ON/OFF switch
SET UP key START/STOP key
Data communication
cable
Analog Channels × 3
(Analog output for CH3 only)
Built-in microphone
Built-in speaker Indicator lamps
0
180 10
Motio n Se nso
CH3 CH2 CH1