DJI Mavic Pro - Manual (Page 7)

Product Profile
Mavic Pro User Manual
© 2016 DJI All Rights Reserved.
7
Preparing the Remote Controller
1. Unfold the mobile device clamps and the antennas.
2. Choose an appropriate RC cable based on the type of mobile device used. An RC cable with a
Lightning Connector has been connected and the Standard Micro USB connector cable and the USB
Type-C connector cable are included. An optional Reverse Micro USB connector cable is available.
Insert the mobile device and secure it.
Unfold the front arms and the propellers before the rear ones. All arms and propellers must be
unfolded before powering on the aircraft, or it may affect Self Diagnostic Testing.
Ensure the Control Mode Switch is toggled to "RC" when using the Remote Controller to control
the aircraft.
You can also connect your mobile device to the remote controller using a USB cable. Plug one end
of the cable into your mobile device and the other end into the USB port on the bottom of the remote
controller. Ensure to disconnect the RC cable from the Micro USB port on the remote controller when
using a USB cable.
Marked Unmarked
Unfold the Arms
1. Unfold the front arms, followed by the rear arms of the aircraft as shown.
2. Unfold all propeller blades.
Refer to the figure below for how to replace the RC cable.
The RC cable slider must be replaced if using an USB
Type-C RC cable.
2
3
1
Micro USB Connector
Reverse Micro USB
Connector
Lightning Connector
USB Type-C Connector