DJI Mavic Pro - Manual (Page 52)

Flight
Mavic Pro User Manual
52 © 2016 DJI All Rights Reserved.
Stopping the Motors
There are two methods to stop the motors.
Method 1: When Mavic Pro has landed, push the left stick down , then conduct the same CSC that was
used to start the motors, as described above . Motors will stop immediately. Release both sticks once
motors stop.
Method 2: When the aircraft has landed, push and hold the left stick down. The motors will stop after three
seconds.
OR
Method 1 Method 2
OR
Flight Test
Takeoff/Landing Procedures
1. Place the aircraft in an open, flat area with the battery level indicators facing towards you.
2. Turn on the remote controller and your mobile device, then turn on the Intelligent Flight Battery.
3. Launch the DJI GO 4 app and enter the Camera page.
4. Wait until the Aircraft Indicator blinks green. This means the Home Point is recorded and it is now safe
to fly. If they flash yellow, the Home Point has not been recorded.
5. Push the left stick up slowly to take off or use Auto Takeoff.
6. Shoot photos and videos using the DJI GO 4 app.
7. Pull down the left stick to descend, the aircraft will hover at 1.5 ft (0.5 m) above the ground for about 1
second, then hold the left stick at its lowest position until you touch the ground and the motors stop.
8. Turn off the Intelligent Flight Battery first, then the Remote Controller.
Stop Motors Mid-flight
Stop motors mid-flight will cause the aircraft to crash. The motors can only be stopped mid-flight when the
flight controller detects a critical error. (This setting can be changed in the DJI GO 4 app)
Starting/Stopping the Motors
Starting the Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom
inner or outer corners to start the motors. Once the motors have started spinning, release both sticks
simultaneously.