DJI Mavic Pro User Manual

Page 27

Aircraft

Mavic Pro

User Manual

DJI Intelligent Flight Battery Functions

1. Battery Level Display: The LED indicators display the current battery level.

2. Auto-Discharging Function: To prevent swelling, the battery automatically discharges to below 65% of

total power when it is idle for more than ten days. It takes around two days to discharge the battery to

65%. It is normal to feel moderate heat being emitted from the battery during the discharge process.

Discharge thresholds can be set in the DJI GO 4 app.

3. Balanced Charging: Automatically balances the voltage of each battery cell when charging.

4. Overcharge Protection: Charging automatically stops when the battery is fully charged.

5. Temperature Detection: The battery will only charge when the temperature is between 5°C (41°F) and

40°C (104°F).

6. Over Current Protection: The battery stops charging when a high amperage (more than 8.5A) is

detected.

7. Over Discharge Protection: To prevent over-discharge damage, discharging automatically stops.

8. Short Circuit Protection: Automatically cuts the power supply when a short circuit is detected.

9. Battery Cell Damage Protection: The DJI GO 4 app displays a warning message when a damaged

battery cell is detected.

10. Sleep Mode: To save power, the battery will cut off power supply and enter sleep mode after 20

minutes of inactivity.

11. Communication: Information pertaining to the battery’s voltage, capacity, current, etc. is transmitted to

the aircraft’s main controller.

Refer to

Mavic Pro Intelligent Flight Battery Safety Guidelines before use. Users take full

responsibility for all operations and usage.

Using the Battery

LED2

LED1

LED3

LED4

Battery Level Indicators

Power Button

Turning ON/OFF

Turning On: Press the Power Button once, then press again and hold for 2 seconds to turn on. The remote

controller system status screen will display the current battery level.

Turning Off: Press the Power Button once, then press again and hold for 2 seconds to turn off.