Logitek Electronic Systems Artisan - Manual (Page 64)

Logitek
Appendix E
Additional Protocol Commands
Surface Configuration – Reset to Defaults
Used to set the Artisan functions to their default locations. (v2.0 and later)
Seq Byte Description Notes
1 <02> Start byte
2 <05> Bytes to follow
3 Command = Set Effect
4 Device Number Any device number on surface (suggest using Fader 1)
5 <41> Type = Surface Config
6 <55> Command Byte <55> = Defaults
7 <01> Data Byte = Set Defaults <01> = Set Defaults
The following example will set the Artisan features to default locations and clear feature locations
from non-volatile memory:
02 05 AE 2C 41 55 01
” TIP: After issuing this command, a power-cycle reset is required. This command should
not be left in Init Triggers or Surface Reset Triggers. It is designed to be used once
only when a NV-RAM clear is required.
Logitek Artisan Reference Manual 62