Logitek Electronic Systems Artisan - Manual (Page 33)

Logitek
5
Operation
MTK-EFFECTS (EQ and Dynamics Module)
Adjustments for Hi Shelf Frequency, Hi Shelf Depth, Hi Mid Frequency,
Hi Mid Depth
, Hi Mid Width, Low Mid Frequency, Low Mid Depth,
Low Mid Width , Low Shelf Frequency, Low Shelf Depth.
Press down on one of the ten equalizer knobs to toggle between coarse;
fine; and ultra-fine adjustment for that setting. The Ring of Fire LEDs show
red for coarse, green for fine, and yellow for ultra-fine control.
Press the IN button to switch equalization in or out for the signal path.
The full color LCD screen shows the current values for each of the EQ &
Compressor
parameters. The name of the input channel or output bus
being adjusted is shown on the top line. An input meter and gain
reduction meter is also shown.
Adjustments for Compressor Attack Time, Compressor Release Time,
Compressor Ratio
, Compressor Depth, Compressor Threshold.
Press down on one of the ten equalizer knobs to toggle between coarse;
fine; and ultra-fine adjustment for that setting. The Ring of Fire LEDs show
red for coarse, green for fine, and yellow for ultra-fine control.
Press the IN button to switch the compressor in or out for the signal path.
Press the EQ, Dyn, Bus or Pan Mode buttons to store the type of settings
for the input channel or mix bus currently assigned to the effects panel.
Press Clear to erase the stored contents.
Press Paste to copy all the stored settings to the input channel or mix bus
currently assigned to the Effects module.
Logitek Artisan Reference Manual 31