Additional protocol commands, Artisan busses, Bus assignments – Logitek Electronic Systems Artisan User Manual

Page 56: Fader functions, Appendix e additional protocol commands, Logitek

Logitek

Appendix E
Additional Protocol Commands

Appendix E Additional Protocol Commands

This section documents Logitek Protocol commands specific to the Artisan surface. These
commands add additional support for functions such as meter bridge feature locations, timer
controls and advanced feature sets.

The standard set of Logitek Protocol commands (such as channel on; channel off; input route;

fader level; etc, is documented in the Logitek Protocol Reference.)

Artisan Busses

These Bus settings supplement/replace the standard busses available in the Logitek system. Please

note the Artisan uses assignment Busses that differ from Logitek radio consoles.

Bus Assignments

BUS0

On/Off Switch

BUS1

Master 1

BUS2

PFL/CUE

BUS3

Master 2

BUS4

Sub-master 1

BUS5

Sub-master 2

BUS6

Sub-master 3

BUS9

Sub-master 4

BUS10

Sub-master 5

BUS11

Sub-master 6

BUS12

Sub-master 7

BUS13

Sub-master 8

TIP:

Aux Sends are not controlled by Bus Assignments but can be externally controlled
using the Set Effects command documented later in this appendix.

Fader Functions

BUS17

Channel On button lamp address

The above Bus is used to address Artisan Color or Flash commands to the fader ON button. The
lamp state is not addressed by this command; instead it is tied to the channel’s BUS0 state.

BUS37

Select mode for “IN” button – OFF = last input / ON = default input

BUS38

Master 1 bus lock (ON = locked)

BUS39

Master 1 bus lock (ON = locked)

BUS40

Sub-master 1 bus lock (ON = locked)

BUS41

Sub-master 2 bus lock (ON = locked)

BUS42

Sub-master 3 bus lock (ON = locked)

BUS43

Sub-master 4 bus lock (ON = locked)

BUS44

Sub-master 5 bus lock (ON = locked)

BUS45

Sub-master 6 bus lock (ON = locked)

BUS46

Sub-master 7 bus lock (ON = locked)

BUS47

Sub-master 8 bus lock (ON = locked)

Logitek Artisan Reference Manual