Lanner FW-7573 - Manual (Page 29)

24
Bios Settings
Chapter 4
Network Application Platforms
USB Mass Storage Driv
In this option, you can enable or disable the attached USB
drive to be used as the system’s hard drive.
USB Hardware Delays a
The menu sets delay time for USB operations.
Item Description
USB transfer
time-out
set transfers to an endpoint to complete
within a specific time.
• If set to zero, transfers will not time out
because the host controller will not cancel
the transfer. In this case, the transfer waits
indefinitely until it is manually canceled or
the transfer completes normally.
• If set to a nonzero value (time-out inter-
val), the host controller starts a timer when
it receives the transfer request. When the
timer exceeds the set time-out interval, the
request is canceled.
Device reset
time-out
This option sets the reset timing for the
USB Mass Storage to be initialized.
When set to 10 Sec, the BIOS will wait for
up to 30 seconds for the USB flash drive to
initialize.
Device
power-up
delay
This option sets the power-up timing for
the USB Mass Storage to be initialized.