Lanner FW-7573 - Manual (Page 11)

6
Hardware Setup
Chapter 2
Network Application Platforms
Chapter 2:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
server. The front panel Power On/Standby button
does not completely shut off system power.
Portions of the power supply and some internal
circuitry remain active until AC power is removed.
Unpower the FW-7573 and remove the power cord. 1.
Unscrew 2 screws on each side and the rear of the top 2.
cover of the FW-7573 System.
Slide the cover backwards to open it. 3.
Installing the System Memory
The motherboard supports DDR3 memory that features
data transfer rates of 1333, 1600 MHz to meet the higher
bandwidth requirements of the latest operating system
and Internet applications. To install the memory:
Open the DIMM slot latches. 1.
Install the DIMM. 2.
Note:
The system can support up to16 GB in maximum. 1.
To activate dual channel, insert memory in both 2.
DIMM1 and DIMM2 slot:
Installing the Hard Disk
The system can accommodate two 2.5” Serial-ATA disks.
Follow these steps to install a hard disk into the FW-7573:
Unscrew the 4 screws on the hard disk tray to take out 1.
the hard disk tray from the system.
Place hard disk on the hard disk tray and align the holes
2.
of the hard disk with the mounting holes on the tray.
Secure the hard disk with 4 mounting screws on the
3.
hard disk tray.
Connect the Serial-ATA power and data disk cables
4.
to the hard disk’s power and drive connector
respectively.
Plug the Serial-ATA cable to the Serial-ATA Connector
5.
on the main board.
Put the hard disk tray with the installed hard disk back
6.
to the system and secure it with the mounting screws.
1
2 1