Lanner FW-7565 - Manual (Page 29)

24
Bios Settings
Chapter 4
Network Application Platforms
Option Description
20 Set this value to stop the AMIBIOS from searching
the IDE bus for IDE disk drives in 20 seconds.
25 Set this value to stop the AMIBIOS from searching
the IDE bus for IDE disk drives in 25 seconds.
30 Set this value to stop the AMIBIOS from searching
the IDE bus for IDE disk drives in30 seconds.
35 Set this value to stop the AMIBIOS from searching
the IDE bus for IDE disk drives in 35 seconds.
ATA(PI) 80 Pin Cable Detection
Set this option to specify the Ultra ATA80 cable detection method.
Option Description
Host Choose this value to use the IDE controller of the
Motherboard to detect the attached IDE cable
type (either 80 or 40 pins).
Device Choose this value to use the IDE hard disk to
detect the attached IDE cable type (either 80 or
40 pins).
Host &
Device Choose this value to use both the IDE hard disk
and the IDE controller to detect the attached IDE
cable type (either 80 or 40 pins). This is the default
setting.
SuperIO Configuration
In this screen, you will be able to modify the IRQ address
of the serial and parallel ports which are provided by the
Winbond 83627THG chip.
Configure Win627THF Super IO ChipSet