beautypg.com

Chapter 4, Bios settings – Lanner FW-7565 User Manual

Page 26

background image

21

Bios Settings

Chapter 4

Network Application Platforms

Option

Description

Disabled

Set this value to prevent the BIOS from using
Multi-Sector Transfer on the specified channel.
The data to and from the device will occur one
sector at a time.

Auto

Set this value to allow the BIOS to automatically
detect device support for Multi-Sector Transfers
on the specified channel. If supported, Set this
value to allow the BIOS to automatically detect
the number of sectors per block for transfer
from the hard disk drive to the memory. The
data transfer to and from the device will occur
multiple sectors at a time. This is the default
setting.

PIO Mode

IDE PIO (Programmable I/O) mode programs timing

cycles between the IDE drive and the programmable

IDE controller. As the PIO mode increases, the cycle time

decreases.

Option

Description

Auto

Set this value to allow the BIOS to auto detect
the PIO mode. Use this value if the IDE disk
drive support cannot be determined. This is the
default setting.

0

Set this value to allow the BIOS to use PIO mode
0. It has a data transfer rate of 3.3 MBs.

1

Set this value to allow the BIOS to use PIO mode
0. It has a data transfer rate of 5.2 MBs.

2

Set this value to allow the BIOS to use PIO mode
0. It has a data transfer rate of 8.3 MBs.

3

Set this value to allow the BIOS to use PIO mode
0. It has a data transfer rate of 11.1MBs.

4

Set this value to allow the BIOS to use PIO
mode 4. It has a data transfer rate of 16.6 MBs.
This setting generally works with all hard disk
drives manufactured after 1999. For other disk
drive, such as IDE CD-ROM drives, check the
specifications of the drive.

DMA Mode

This setting allows you to adjust the DMA (Direct memory

access) mode options.

Option

Description

Auto

Set this value to allow the BIOS to automatically
detect the DMA mode. Use this value if the IDE
disk drive support cannot be determined. This is
the default setting.

SWDMA0

Set this value to allow the BIOS to use Single
Word DMA mode 0. It has a data transfer rate of
2.1 MBs.

This manual is related to the following products: