Lanner LVC-5570 - Manual (Page 28)

28
Flow Chart
Chapter 4
Embedded and Industrial Computing
Chapter 4:
The Flow Chart
The flow chart section contains all flow chart used in the
system. The flow chart describes the system’s behavior on
powering on and off the system via power ignition control
or on/off switch when the appropriate timer control
parameters are set.
Note:
For power-good and low-voltage 1.
mechanism to function in the workflow,
you will need to enable the power-good
and low-voltage detection function
with selector 1 and selector 2 jumper
respectively of SW1 on LEK-IG1 board.
(Refer to Chapter 3 Board Layout).
For power on and power off delay timer 2.
parameter, refer to Appendix A Using the
Ignition System Manager (ISM).
For 3G wake-up and DI wake-up 3.
function, refer to jumper MCARD1(Mini-
PCIe) and J3 (DIO) respectively. Refer to
Chapter 3 Board Layout and Appendix
A Using the Ignition System Manager
(ISM) for jumper setting and parameter
setting.
When the system’s shutdown timer starts 4.
counting down 180sec, using ignition
or External PWR_BTN to start the system
again during shutdown process will not
work until the countdown finishes.