Lanner LVC-5570 - Manual (Page 11)

11
System Components
Chapter 2
Embedded and Industrial Computing
Rear Components
Component Description Pin Definition Reference
R1 Power-In (DC) Power-in with ignition support. The
LVC-5570 support a wide range of
power input (+9V ~ +36) including
the prevalent 12V and 24V vehicular
power system. It has a 2KV ESD
protection on the DC input and
ignition line.
DC_IN Connector (CN3) on page
25
R2 DC Relay Bypass 9~36V, 10A (GND, Power-Out)
Integrated in 1x 4-pin terminal block
CN2 on page 21
R3 Two USB 2.0 Ports USB type A connectors Dual USB Port Connector #4 and
#5 (USB3) on page 25
R4 Two 10/100/1000Mbps LAN
ports
Two RJ-45 (network) jacks with LED
indicators as described below
LINK/ACT (Yellow)
On/Flashing: The port is linking •
and active in data transmission.
Off: The port is not linking.
•
SPEED (Green/Amber)
Amber: The connection speed is •
1000Mbps.
Green: The connection speed is
•
100Mbps
Off: .The connection speed is
•
10Mbps.
LANB1/LANB2 on page 25
R5 DVI-D (*) A DVI-D port (single link) which
is provided by Intel HD Graphic
Engine. This port can support up to
1920x1200@60Hz resolution.
DVID1 on page 23
R6 HDMI Port (*) A DVI-D port (single link) which is
provided by Intel HD Graphics 3000
(resolution: 1920x1200@60Hz).
HDMI1 on page 23
R7 VGA Port (*) It connects an external VGA
monitor or projector (resolution:
2048x1536@75Hz)
VGA1 on page 23
R8 GPS Antenna It connects an antenna for the build-
in GPS module.
R9 Serial Ports (from left to right:
COM1/COM2)
COM1 and COM2 provide RS232/
RS422/RS485 communications with
a dip switch selecting among these
standards.
RS-232 COM Port (COM1, COM2)
on page 19
R4
R5
R3 R1
R11
COM1 COM2
R6 R7
R2
R8
R10
R9
R12
LINK/ACT
SPEED