Lanner LVC-2000 - Manual (Page 20)

20
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Chapter 4:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from
the server. The power switch button does not
completely shut off system power. Portions of the
power supply and some internal circuitry remain
active until power is removed.
1. Unpower the LVC-2000 and remove the power cord.
2. Remove 4 threaded screws from the bottom to take off
the bottom cover.
3. Open the cover.
HDD Installation
The system can accommodate one Serial-ATA disk. Follow
these steps to install a hard disk into the system:
1. Take out the hard disk tray and fix the hard disk on
the tray with 4 mounting screws as illustrated in the
following picture.
2. Plug the Serial-ATA cable to the hard disk.
3. Place the hard disk back to the system’s chassis and fix
it with the mounting screws.
4. Connect the Serial-ATA power and data disk cables to
the Serial-ATA power and disk connectors on the main
board respectively.
1 2
3 4