Lanner LVC-2000 - Manual (Page 14)

14
Board Layout
Chapter 3
Embedded and Industrial Computing
Connectors and Jumpers List
The tables below list the function of each of the board
jumpers and connectors by labels shown in the above
section. The next section in this chapter gives pin
definitions and instructions on setting jumpers.
Table 3.1 Connector List for External Connectors
Labels Function Pin Definition Refer-
ence Page
CAN1 CAN bus Connector
COM1/COM2 RS-232 Commmunication Ports P
HDMI1 High Definition Multimedia Interface P
MIO1 Multiple I/O Connectors
PRJK1 3-Pin DC-in Power Connector with Ignition Control
USB2 USB 3.0 Connector P
VGA1 VGA Connector
Table 3.2 Connector List for Internal Connectors
Labels Function Pin Definition Refer-
ence Page
AUDIO1 Audio Pin Header P
JCMOS1 Clear CMOS Jumper P
JMCU1 MCU Programming Jumper P
JSPI1 Serial Peripheral Interface Bus Reserved for factory use
JLPC1 Low-pin Count Pin Header P
JRI1/JRI2 COM1/COM2 Power Selection
MPCIE1/MPCIE2 Mini-PCIe Connector 1/2 P
mSATA1 mSATA Connector P
JKBMS1 Keyboard/Mouse Connector P
JRI1 COM1 Power Selection P
JRI2 COM2 Power Selection P
SATA1 SATA Driver Connector P
SATAPWR1 SATA Power Connector P
SIM1 SIM Card Connector Reserved for factory use
USBF1 USB 2.0 Pin Header P