KACO Powador-gridsave User Manual
Page 15

Installation
Battery unit extension - Panasonic / Sanyo for Powador-gridsave
Page 15
1
2
3
Figure 1: Fit the fixing bracket onto the battery
Key
1
Battery
3
Fixing bracket
2
Fixing screws (M3x10)
Step 1: Fit the battery (batteries)
↻ Preparation complete.
1. Fit the fixing bracket provided onto the battery using fixing screws
(M3x10) at the required torque of 0.78 Nm.
(See Figure 1 on page 15)
2. Insert the battery into the corresponding battery compartment on the
energy storage system in the correct position and pole alignment and
secure using the fixing screws (M5x12).
»
Check the battery(ies).
NOTE
Before starting, check the idle voltages of the batteries.
In individual cases, it may be that the idle voltage (ULL) of the indi-
vidual battery modules vary.
The maximum deviation permitted between the individual batteries
is 0.5 V !