KACO Powador-piccoLOG - Manual (Page 14)

Installation and Start-up
Page 14 Operating manual Powador-piccoLOG_EN
5.4 Connecting the inverter
654321
RS485 B
RS485 A
1
2
3
4
5
6
GND
+24V
A
B
RJ12
A
B
1 2
3
4
5
6
Figure 4: Connecting the inverter
1 RJ12 plug/ RS485 4 RS485 B / RS485- / -TR / T-
2 Signal name 5
RS485 A / RS485 + / +TR /
T+
3
Bus cable (twisted and shielded wire
pair) for the Powador-piccoLOG
6 Inverter
NOTE
See the inverter manual for details on bus configuration.
• To connect, use a ready-made connection cable or manufacture
one according to the above pin configuration.
• We recommend the use of UNITRONIC® Li2YCYv (TP) cables,
produced by "LappKabel", or equivalent. This cable is suitable for
installation directly into the earth.
Bus configuration
" Remove protective cover.
" Connect inverter with an RJ12 connection jack (see 5.2 "Interface
overview").
» If there is no inverter already installed, the device will automatically search
for an inverter once switched on.
» Perform a manual search with the software
(see 5.9 "Powador-piccoLOG Device Manager").