Yaskawa GPD506/P5 with Apogee FLN Option - Manual (Page 10)

9
3.2 Logical Analog Output (LAO) Summary
Point Description Point #
GPD505
Parameter
GPD506/P5
Parameter
Units
(SI)
Slope Intercept
Default Min Max
Override Time 20 n/a n/a Hrs 1.0 0 8 1 12
Acceleration Time 31 n019 n018 Sec 0.1 0 10.0 0 3276.7
Deceleration Time 32 n020 n019 Sec 0.1 0 10.0 0 3276.7
Freq Command Upper
Limit
38 n030 n031 % 1.0 0 100 0 109
Freq Command Lower
Limit
39 n031 n032 % 1.0 0 0 0 100
Operational Mode
Select
55 n002 n002 - 1.0 0 6 0 8
Frequency Command 60 n/a n/a Hz 0.1 0 0 0 Note 1
PID Proportional Gain 63 n086 n086 - 0.1 0 1.0 0.0 10.0
PID Integral Time 64 n087 n087 Sec 0.1 0 10.0 0.0 100.0
PID Mode Select 65 n084 n084 - 1.0 0 0 0 3
Read Parameter
Number
70 n/a n/a - 1.0 0 0 1 114
Write Parameter
Number
72 n/a n/a - 1.0 0 0 1 114
Write Parameter Data 73 n/a n/a - 1.0 0 0 0 9999
Cable Loss Frequency 91 n/a n/a Hz 0.1 0 0 0 Note 1
Cable Loss Timeout 92 n/a n/a Sec 0.1 0 0 0 3276.7
Notes
1. Value dependent on maximum output frequency of the drive. Default is 60.0 Hz.
3.3 Logical Digital Input (LDI) Summary
Point Description Point #
Off (0)
State
On (1)
State
Forward/Reverse Monitor 21 Forward Reverse
Run/Stop Monitor 23 Stopped Running
Drive Ready Monitor 35 Not Ready Ready
Multifunction Output 1 40 Note 1 Note 1
Multifunction Output 2 41 Note 1 Note 1
Terminal S1 Monitor 42 Open Closed
Terminal S2 Monitor 43 Open Closed
Terminal S3 Monitor 44 Open Closed
Terminal S4 Monitor 45 Open Closed
Terminal S5 Monitor 46 Open Closed
Terminal S6 Monitor 47 Open Closed
Fault Monitor 93 Not Faulted Faulted
Notes
1. States are dependent on the setup of the Multifunction Outputs. Refer to appropriate Technical
Manual.
3.4 Logical Digital Output (LDO) Summary
Point Description Point #
Off (0)
State
On (1)
State
Default
Forward/Reverse
Command
22 Forward Reverse Off
Run/Stop Command 24 Stop Run Off
Terminal S3 Command 25 Open ( See Note 1 ) Closed ( See Note 1 ) Off
Terminal S4 Command 26 Open ( See Note 1 ) Closed ( See Note 1 ) Off
Terminal S5 Command 27 Open ( See Note 1 ) Closed ( See Note 1 ) Off
Terminal S6 Command 28 Open ( See Note 1 ) Closed ( See Note 1 ) Off
Day/Night Mode Selection 29 Day Mode Night Mode Off