Yaskawa MP2000iec - Manual (Page 21)

5 Mounting
YASKAWA America, Inc. MP2300iec Hardware Manual YAI-SIA-IEC-2R 21
„
Screw Mount Method
Use a panel mounting bracket (JEPMC-OP2300S-E) using the following procedure to mount an MP23 ͙͙͙ iec on the
panel. This adapter is only required if screw mounting an MP2300Siec.
1. Release DIN fixing locks (two) at the center of the panel mounting clamp.
2. Insert two convex portions at the top of the panel mounting clamp into holes of the controller chassis.
3. Push the clamp as indicated by an arrow above onto the controller chassis and use the DIN fixing locks to secure the
mounting clamp.
4. Push the MP2300Siec mounted clamp onto the mounting plate as shown in the figure below, and use four mounting
screws to firmly secure the clamp.
Two convex clamps
Two DIN fixing
lock positions
When locked
When released
Attachment for mounting bracket
&%
4.; 176 'VJGTPGV
&%
8
.+0-
/
0V
Opti
o
n S
lo
t
;#5-#9#
6'56
4&;
#./
/6:
64:
470
'44
$#6
+2
59
59
/10
%0()
+06 572
5612
$#66'4;
㪧㪦㪮㪜㪩
'
M- I/II
+0+6
01
01 '6'56
MP2300Siec
Mounting screw
(M4 plus)
On this portion, use the screwdriver
of no less than 10 cm in length.
Note: Vertically mount as shown.
#3 #4
#2 #1