Yaskawa MP2000iec - Manual (Page 14)

3 Specifications
14 YASKAWA America, Inc. MP2300iec Hardware Manual YAI-SIA-IEC-2R
‹
Specifications of Controller
MP2300Siec Hardware Specifications
Item Specifications
Classification Controller
Name MP2300Siec
Model Number PMC–U–MP23S ͙͙͙͙ (see page
16
)
Power Unit
Input Voltage 24VDC (± 20%)
Input Current 1A Max (during input/output rating)
Inrush Current
40A Max (full discharge state, during output rating, or the secondary output of the external
24V power supply is turned ON)
Rated Voltage 5.0V
Rated Current 2.0A
Output Current Range 0.0 to 2.0A
Constant Voltage
Precision
±2% Max (including input voltage and output load fluctuations)
Battery Battery for memory retention attachable
Motion Network
MECHATROLINK-II: 1 channel
SERVOPACK and I/O for up to 20 slave nodes connectable
(SERVOPACK for up to 20 axes)
Baud rate: 10 Mbps (MECHATROLINK-II)
Communication Function Ethernet: 100BASE-TX/10BASE-T
Calendar
Seconds to year timer
(Battery backup)
Connectors Power supply to Ethernet RLY OUT
Indicators
RDY(green), RUN(green), ALM(red), ERR(red), MTX(green), BAT(red), TRX(green),
IP(green), LINK(yellow), 100M(green)
Switches STOP, SUP, INIT, CNFG, MON, TEST, E-INIT, E-TEST
Current Consumption 1A Max
Dimensions (mm) 64 x 130 x 108 (W x H x D)
Mass 390 g
• For the external 24V power supply, select a power supply which satisfies the specifications below as well as
the rated current (not more than 1A):
• Allowable output load capacity: 1200 μ F or more
• Overcurrent detection is automatically restored by removing causes
• However, except that the primary side (AC side) of the external 24V power supply is turned ON/OFF.