Yaskawa MP2000iec - Manual (Page 15)

3 Specifications
YASKAWA America, Inc. MP2300iec Hardware Manual YAI-SIA-IEC-2R 15
MP2310Siec Hardware Specifications
Item Specifications
Classification Basic Module
Name MP2310
Model Number JEPMC-MP2310-E
Power Unit
Input Voltage 24VDC (± 20%)
Input Current* 1 A max. (during input/output rating)
Inrush Current*
40 A max. (full discharge state, during output rating, or the secondary output of the external
24V power supply is turned ON)
Rated Voltage 5.0 V
Rated Current 2.0 A
Output Current Range 0.0 to 2.0 A
Constant Voltage
Precision
±2% max. (including input voltage and output load fluctuations)
Battery Battery for memory retention attachable
Flash Memory 12 MB (User area 7.5 MBytes)
SDRAM 32 MB
SRAM 2 MB: M registers, S registers, trace memory, alarm history (Battery backup)
Motion Network
MECHATROLINK: 1 channel
SERVOPACK and I/O for up to 21 stations connectable (SERVOPACK for up to 20 axes)
Baud rate: 4 Mbps (MECHATROLINK-I) or 10 Mbps (MECHATROLINK-II)
Communication Function Ethernet: 100BASE-TX/10BASE-T
Calendar
Seconds to year timer
(Battery backup)
Connectors
POWER: Power supply connector
M-I/II: MECHATROLINK connector
Ethernet: Ethernet connector
Indicators
RDY(green), RUN(green), ALM(red), ERR(red), MTX(green), BAT(red), TRX(green),
IP(green), LINK(yellow), 100M(green)
Switches STOP, SUP, INIT, CNFG, MON, TEST, E-INIT, and E-TEST
Current Consumption 1A max.
Dimensions (mm) 120 × 130 × 108 (W × H × D)
Mass 450 g
• For the external 24V power supply, select a power supply which satisfies the specifications below as well as
the rated current (not more than 1A):
• Allowable output load capacity: 1200 μ F or more
• Overcurrent detection is automatically restored by removing causes
• However, except that the primary side (AC side) of the external 24V power supply is turned ON/OFF.
Note: Recommended external 24V power supply: RTW24-2R2 (manufactured by TDK)