Yaskawa VS-616G5 DeviceNet Communication Interface Card SI-M2 - Manual (Page 3)

VS-616G5 Option Instruction Manual: DeviceNet™ Communication Interface Card SI-M2 Page 3
INTRODUCTION
The DeviceNet  Communication Interface Card SI-M2 is mounted on the control board (2CN connector)
of a VS-616G5 inverter, and is used to connect to and communicate with a DeviceNet  communication
network. When purchasing an option card, please specify the inverter model and code number.
SI-M2 Option Card Description
Name Code Number Functions
DeviceNet  Communication
Interface Option Card SI-M2
(YEA Order P/N UTC000018)
73600-C0200
• Connects inverter to a DeviceNet  communication network .
• Custom software required to use option card. Software number
VSG11005X (where X: minor revision number, 0-9 are valid).
• All DeviceNet  objects required to meet the standard AC Drive
type are supported.
• The VS-616G5 inverter communicates on DeviceNet  as a
Group 2 only server.
• The pre-defined Master/Slave set must be used.
• Option card plugs into 2CN connector on the control board.
Fig. 1 DeviceNet  Communication Interface Option Card SI-M2
Grounding lead wire
(connect to terminal#12
of inverter control board)
60-pin Connector
to inverter control
board (2CN)
Terminal block TB1
Stand-off mounting
hole (4.0mm) dia.
2CN 1
2
3
4
SI-M2
E
5
73600-C0200
CODE NO.
GND
TP8 TP7 TP5
TP2 TP1
TP3
TP4
TP6
TP9
V
C
C
IG
N
D
V-
V
+
VDD
Rx Data
Tx Data
Stand-off mounting
hole (4.0mm) dia.
V-
CAN-
Earth
CAN+
V+