Yaskawa GPD 515/G5 to F7 - Manual (Page 31)

Product Transition Guide
Appendix 2- Parameter Differences
____________________________
PL.F7.02.TransitionGuide 6/5/06
Page 31 of 40
Yaskawa Electric America, Inc
GPD515/G5 Parameters F7 Parameters
Parameter
No.
Name
(DigitalOperator
Display)
Setting or Selection
Parameter
No.
Name
(Digital Operator Display)
Remarks on
Setting or Selection
— — — F5-03 DO-08 Channel 3
Output Selection New Parameter
— — — F5-04 DO-08 Channel 4
Output Selection New Parameter
— — — F5-05 DO-08 Channel 5
Output Selection New Parameter
— — — F5-06 DO-08 Channel 6
Output Selection New Parameter
— — — F5-07 DO-08 Channel 7
Output Selection New Parameter
— — — F5-08 DO-08 Channel 8
Output Selection New Parameter
— — — F5-09 DO-08 Output Mode
Selection New Parameter
0:8-channel individual
outputs.
1:Binary code output.
2:Output according to
F5-01 to F5-08 settings.
F9-02 Option External
Fault Detection
Selection 0:Always Detected
1:Only During Run F6-02 Option External Fault
Detection Selection Changed Parameter No.
F9-03 Option External
Fault Detection
Operation Selection 0: Ramp to Stop
1: Coast to Stop
2: Fast - Stop
3: Alarm Only F6-03 Option External Fault
Detection Operation
Selection Changed Parameter No.
F9-04 Trace Sampling
Time — F6-04 Trace Sampling from
Communications
Option Board
Changed Parameter No.
— — — F6-05 Current Monitor
Display Unit Selection New Parameter
0: Displayed in Amps
1: 100%/8192
F9-05 TorqueReference/
Torque Limit
Selection through
DP-RAM
communication 0: Disabled
1: Enabled F6-06 Torque
Reference/Torque
Limit Selection through
DP- RAM
communication Changed Parameter No.
F9-06 DP-RAM
Communication
Error Detection
Operation Selection 0:Ramp to Stop
1:Coast to Stop
2:Fast - Stop
3:Alarm Only F6-01 DP-RAM
Communication Error
Detection Operation
Selection Changed Parameter No.