Yaskawa JVOP-180 LCD - Manual (Page 49)

6 Basic Operation
YASKAWA ELECTRIC TOBP C730600 29G 1000-Series Option JVOP-180 Installation Manual 49
Read/Copy Function Procedure
• Read
Reads and saves parameter settings from the regenerative unit to the option.
Note: The option can perform the Read function an estimated 100,000 times.
• Copy
Copies parameter settings from the option to another Yaskawa regenerative unit.
These parameters control the Copy function of the digital operator. The Copy function
stores parameter settings into the memory of the digital operator to facilitate the transfer
of those settings to other regenerative units that are the same model, capacity, and same
control mode setting.
Note: Parameter settings can only be copied to other regenerative units that are the same model,
capacity, and have the same control mode setting.
• Verify
Verifies that parameter settings in the regenerative unit match the parameter settings saved
to the option.
The following procedure is used to read parameters from the regenerative unit.
Note: Set parameter o3-02 (Read Allowable) to 1 (Enable) to read the parameter settings from the
regenerative unit.
Set parameter o3-02 to 0 (Disable) to protect the parameter settings in the option.
Procedure LCD Display
1. DC Bus Voltage Reference display.
2. Press to select the Programming Mode.
3. Press to show the Initialization display.
- MODE -
U1-51= 0330V
U1-52= 295V
U1-53= 0.0A
DRV
DC V Feedback
Rdy
LSEQ
LREF
HELP
-MODE- PRG
DATA
Programming
← →
-PRMSET-
Initialization
Select Language
PRG
A 1-00=0