Connecting the option to the unit, V1000, 5 installation procedure – Yaskawa JVOP-180 LCD User Manual
Page 26
5 Installation Procedure
26
YASKAWA ELECTRIC TOBP C730600 29G 1000-Series Option JVOP-180 Installation Manual
◆
Connecting the Option to the Unit
This section contains instructions for connecting the option to units.
■
Connecting the Option to V1000
Plug the customer-supplied communication cable into the communication cable connector of
the option and the drive communications port as shown in
. Ensure both cable
ends are firmly connected.
Refer to Item Names and Part Numbers (Sold Separately) on
for information regarding recommended cables.
Refer to
for built-in LED display behavior with a connected option.
Note: 1. Use only Yaskawa recommended cables. Using a cable not specified may cause the option or drive to
malfunction.
2. The STOP key on the built-in LED operator of the drive is the only functional key on the drive when the
option is connected and parameter b1-02 is set to 0 (LCD Operator or Option). Set parameter o2-02
(STOP Key Function Selection) to 0 (Disable) to disable the STOP key.
Figure 15
Figure 15 Communication Cable Connection
STOP
V1000
(Hz)
(Hz)
(A)
(V)
:
:
:
:
:
:
:
:
:
:
周波数指令
正転逆転選択
出力周波数
出力電流
出力電圧
モニタ
ベリファイ
セットアップ
パラメータ設定
オートチューニング
据え付け、運転の前には必ず取扱説明書を読むこと。
通電中および電源遮断後
5
分以内はフロントカバーを
外さないこと。
400V
級インバータの場合は、電源の中性点が接地
されていることを確認すること。（ 対応）
けが、感電のおそれがあります。
危 険
Read manual before installing.
Wait 5 minutes for capacitor discharge after
disconnecting power supply.
To conform to requirements, make sure
to ground the supply neutral for 400V class.
Risk of electric shock.
WARNING
S / N : J007XE273710001
Comm Port
LED
Operator
Communication Cable Connector
Option
Drive