SMA RS485-Quick Module - Manual (Page 29)

SMA America, LLC Decommissioning and disposal
Installation Guide RS485-QM-IA-eng-IUS111610 29
6 Decommissioning and disposal
6.1 Decommissioning
1. If the multi-function relay is connected: switch off the multi-function relay power supply.
2. Open SMA DC-Disconnect (see section 5.1 „Open SMA DC-Disconnect.“ (page 19)).
3. Pull the RS485-Quick Module downwards to the
stopper.
4. Open the cover of the RS485-Quick Module and disconnect all the cable connections in the
RS485-Quick Module.
5. Pull the cables out of the RS485-Quick Module and close the cover of the
RS485-Quick Module.
6. Lay the thumbs on the upper edge of the RS485-
Quick Module and push the RS485-Quick Module
downwards using your thumbs. When the
RS485-Quick Module is at the end of the bracket,
push the bottom edge of the RS485-Quick Module
forwards.
☑ The RS485-Quick Module is disassembled.
6.2 Disposal
Dispose of the RS485-Quick Module at the end of its
service life in accordance with the disposal regulations for electronic waste which apply at the
installation site at that time. Alternatively, send it back to SMA with shipping paid by sender and
labeled "ZUR ENTSORGUNG" ("FOR DISPOSAL") (contact: see Page 31).