SMA RS485-Quick Module - Manual (Page 15)

SMA America, LLC Preparations for the RS485-Quick Module
Installation Guide RS485-QM-IA-eng-IUS111610 15
Configuration of the RS485-Quick Module After Installation
1. If the multi-function relay is already connected, switch off the multi-function relay power supply.
2. Open SMA DC-Disconnect (see section 5.1 „Open SMA DC-Disconnect.“ (page 19)).
3. Pull the RS485-Quick Module out to the stopper.
4. Flip up the flap of the RS485-Quick Module and lift
the cover until it snaps into place.
5. Set the installation country and display language (see section 4.3.1 „Setting the language and
installation country via the rotary switch“ (page 14)).
6. Set the NetID for Bluetooth communication unit (see section 4.3.2 „Communication via
Bluetooth“ (page 16)).
7. Close the cover of the RS485-Quick Module and
fold back the flap so that it snaps into place.