SMA RS485-Quick Module - Manual (Page 14)

Preparations for the RS485-Quick Module SMA America, LLC
14 RS485-QM-IA-eng-IUS111610 Installation Guide
4.3 Configuring the RS485-Quick Module
4.3.1 Setting the language and installation country via the rotary
switch
Configuration of the RS485-Quick Module Before Installation
If you have not yet installed the RS485-Quick Module, proceed as follows to set the installation
country and the language:
1. Flip up the flap of the RS485-Quick Module and lift
the cover until it snaps into place.
2. Using a screwdriver of width
1
⁄
8
in. (2.5 mm), set
the arrows on the two left-hand rotary switches
(A and B) to the desired position. The meaning of
the positions of the rotary switches in the RS485-
Quick Module are the same as in the Standard
Quick Module. Please read the inverter's
installation guide to find the meaning of the rotary
switches.
☑ The language and installation country have been set.
Jumper for English
You have the possibility to change the
language setting to English using a jumper
(e.g., during maintenance).
• Pull the jumper from the two right-hand
pins and attach it to the two left-hand
pins.
As soon as you have completed the work:
• Pull the jumper from the two left-hand pins and attach it to the two right-hand pins.